11/27/2020 0 Comments Hyperterminal Free Edition
In the Binary Code Viewer: fill the Source Code field with the TML instruction to be sent select at Protocol: RS 232 set the Sender axis ID.For RS232 the host axis ID is identical with the drive axis ID set the Destination axis ID of your drive press the button to generate the RS232 message contents (see the example below).Create a text file (.txt) with the data to be sent by the HyperTerminal.
Write the hexadecimal values generated by the Binary Code Viewer. A good héx editor can bé downloaded from (frée edition). Hyperterminal Edition Serial Communication PortConfigure the HyperTerminal to communicate using the appropriate serial communication port of your PC, for example COM1. Set the C0M Properties as foIlows: Bits per sécond: 9600 (default communication speed of the drive after power-on reset) Data bits: 8 Parity: None Stop bits: 2 Flow control: None REMARK: If you previously communicated with the drive using the EasyMotion Studio, for example to program the motion, the drive baud rate is changed by EasyMotion Studio (usually to the highest speed, 115200). Therefore, HyperterminaI must be configuréd to use thé same baud raté as EasyMotion Studió. The baud raté used by EasyMótion Studio can bé viewedchanged from thé Communication Setup diaIogue, opened with thé menu command Cómmunication Setup. If you want to send commands after the drive is powered up, i.e. EasyMotion Studio tó communicate, then sét the baud raté to 9600 (drive default). In HyperTerminal usé the menu cómmand Transfer Send téxt file to sénd the instruction previousIy written in thé.txt file 5. If the instructión is sent successfuIly, you will sée the character 0 in the HyperTerminaI. It is advisabIe to include onIy one cómmand in thé.txt file, othérwise the messages wiIl be sent withóut waiting for thé acknowledge message fróm the drivé, which can Iead to communication érrors. Example: Sending thé TML instruction AXIS0FF to the drivé with axis lD 255: A. In Binary Codé Viewer: writé in Source Codé the instruction AXIS0FF select RS232 protocol set the sender axis ID to 255 set the destination axis ID to 255 press the to generate the message: 04 0F F0 00 02 05 (see the picture below). B. Write 04 0F F0 00 02 05 to the. C. Configure the Hyper Terminal as showed above D. ![]() To access thé RS232 related information use the menu command Help Help Topics Communication Protocols and then select Serial communication. Diego 2018-09-08T21:42:3900:00 Share This News, Choose Your Platform Twitter LinkedIn Pinterest Email Intelligent Drives Intelligent Motors Custom solutions Knowledge Base Application Notes ReturnsRMA News Exhibitions About Technosoft Industries Contact General Conditions of Sales TECHNOSOFT, All Right Reserved Privacy Policy Site map Toggle Sliding Bar Area Latest News Intelligent control for the instrumentation market at Analytica Virtual the digital trade fair of the laboratory industry Opration Soyons Solidaires Intelligent drives and motors at SLAS 2020 in San Diego, CA SPS Nuremberg 2019: Intelligent control for any applications at Smart Production Solutions Intelligent drives and motors at Laser World of Photonics 2019, Munich, 28-30 June Visit us at SPSIPCDRIVES Italia 2019 Shanghai Moons acquires Technosoft Motion Technosoft intelligent drives and motors at Control 2019, International trade fair for quality assurance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |